How to control your TV with your Astro B.yond remote control

astro byond remote map

Finally configured my B.yond remote to control my TV.

There are are 2 ways to configure your remote.

Method 1:

  1. Hold down the tv(power)  and power buttons together  until the indicator blinks twice.
  2. Refer to the table below and key in the 4 digit number that represents your TV brand.
  3. If the code was valid the indicator will blink twice again.
  4. Press the tv(power) button, if your TV turns off then the code worked else repeat the steps and try another code from the table.



Method 2:

  1. Hold down the tv(power)  and power buttons together  until the indicator blinks twice.
  2. Key in 9 – 9 – 1. The indicator should blink twice again.
  3. Press the tv(power) button, aim the remote at the decoder and press the ch+(channel up) button.
  4. Wait 3 seconds. If the TV does not turn off, press the  ch+(channel up) button and wait for 3 seconds again. Repeat the steps until the TV turns off.  You’re basically iterating through the TV codes in the remote’s database.
  5. Press the OK button once you find the correct code.

Source: Astro’s Remore Setup Manual PDF

  • lol


  • lol

    how to sleep with eyes open ??

  • joker90

    How to reconnect rmote astro from tv

  • virus

    OMG U got the 1 step wrong. The frist step should be press and hold tv/power + menu button together till blink twice ,
    and is not Tv/power +power button! It wont blink no matter u hold both key for an hour

  • Hello Admin, please do correct the instruction. You need to press tv/standby + OK button, blink twice then you enter any of the codes (your tv models). That’s it.

  • Fareez Hafiz

    I use PHISON PR-888…
    How to connect to astro and tv

  • cikgusyedsyco

    Damn.. Wrong instructions.. 1st step is already wrong.. You should press the “tv power” button + “OK” button. Then the indicator will blink. ?

  • Nive Nathan

    It screwed my HDMI i have to reset the hdmi everytime i turn on the tv

  • AJ

    Cilaka…cuba dah 2 jam pun tidak boleh!

  • AJ

    Ok dah boleh. Kena tekan lama sikit

© 2008-2012 The Danesh Project
Powered by Wordpress and made by Guerrilla. Hosted at ServerFreak